Old 29-06-2020, 09:05 PM
Tasaurora (Si)
Registered User

Tasaurora is offline
Join Date: May 2020
Location: Huonville
Posts: 18
Variations in temp - collimation

Iím a newbie to this site and the astronomy world in general and I have spent wayyy too much time reading posts - one thing, if I may offer the community in regards to responses (especially in the beginner section ) - could ppl please be aware that as beginners, we do not know, what we donít know. So the acronyms and the 3 letter references within some replies no doubt make perfect sense to long termers - But I often find myself sidetracked looking up reference after reference, and then - well going off to watch a funny dog video :-)

Iím guilty of the exact same thing in my other, established hobbies - and someone bought it to my attention re the same I ssues it can cause - and I for one, want more ppl involved in the hobbies I choose.

To my query if I may - my scope lives inside where itís 21-22 degrees C for most of the night. When I take it outside itís often 1-2 degrees. This causes not only condensation to build quickly - but I can hear the scope creaking and ďcrackingĒ as it cools down. Is this a problem? Can it cause collimation issues? How do ppl deal with condensation in the field ?

I got to use my 10Ē dobson for the 1st time the other night and kids went mad for Saturn - but it was a little blurry regardless of eye pieces I trialled.
I also made a bad error, getting the kids to look early in the night - looking through a lot of atmosphere To the east rAther that waiting until closer to vertical - silly, but time was a problem.

Iíve looked at collimation links on here and am about to buy a Cheshire and laser - is collimation something one should check every night - after travel - intermittently? Again - I donít know what I donít know - so perhaps I need collimation now after interstate transport...how far out is too far out ?

One other Question - Iíve not yet set up skyscan because I cannot get a perfectly level site and donít want to put feet into the grass / dirt - as this might introduce backlash as the ground is very soft - I imagine this is critical? So build a board or sheeting is a decent idea?

Thanks in advance for all assistance- so, so much info on here. Gave me absolute chills seeing Saturn come into focus - I was like one of the kids myself
Reply With Quote
Old 30-06-2020, 11:18 AM
Tulloch's Avatar
Tulloch (Andrew)
Registered User

Tulloch is offline
Join Date: Sep 2019
Location: Melbourne
Posts: 354
Hi there, before using your scope you should leave it outside for a few hours to reach ambient temperature (this will stop air currents inside the OTA and so the images will be more stable). I also use a BBQ cover over my scope so that condensation doesn't form on the scope while it's cooling.

To deal with fogging/condensation I use a portable fan heater and blow warm air over the corrector plate (on my SCT). After a couple of minutes to cool down again, it should be fine for the next 15 minutes or so.

In a few months the planets will be viewable at a more reasonable time of the night

Reply With Quote
Old 30-06-2020, 11:55 AM
Startrek (Martin)
Registered User

Startrek is offline
Join Date: Dec 2017
Location: Sydney
Posts: 2,963
I have a Skywatcher 12Ē Goto dob and use Kendrick dew heaters under the secondary mirror , around the finder scope and sometimes on eye pieces ( depending on the severity of dew ) to combat the onset of dew which can ruin your night.The primary mirror is rarely affected by dew
Iím assuming your 10Ē is a Goto Scope not a manual push , pull , nudge ?

If your going to use it continually in the backyard and not elsewhere, Iíd recommend to buy a precast concrete pad /s and set them level under a bed of gravel so you have a permanent reliable observing platform for your scope to sit on each time you use it ( or alternatively on a driveway or paved entertainment area or the like ) I think a 10Ē base is only around 500mm in diameter and I know you can buy precast 600mm x 60mm thick concrete pads from Bunnings

Many factors can contribute to poor observing especially planets -
Mould, salt , oils etc on mirrors
Pinched primary mirror
Jetstream and atmospheric turbulence
Light pollution
Moon glare
Bad Focus
Over magnification
Poor quality eye pieces
Low observing altitudes
Etc .......

PS: I know you hate acronyms but get use to it , the hobby is full of them especially Astrophotography !!!!

Welcome , good luck and enjoy your new journey throughout the universe

Clear skies !
Reply With Quote
Old 01-07-2020, 11:52 AM
Tasaurora (Si)
Registered User

Tasaurora is offline
Join Date: May 2020
Location: Huonville
Posts: 18
Thanks for replies -have given me even more to think about lol.

I donít mind acronyms when I know or understand - like anyone I guess - itís just when starting out it can be like learning a new language...

My sky watcher dob (see, itís creeping in for me now lol) is a GOTO - but at present, Iíve just been using the hand held device to move the scope and the finder scope.

Might look at setting up a dedicated area and even pour a small slab.

Thanks again.
Reply With Quote


Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT +10. The time is now 04:21 PM.

Powered by vBulletin Version 3.8.7 | Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
NexDome Observatories
Limpet Controller
Astronomy and Electronics Centre