#1  
Old 01-12-2012, 02:41 AM
astrognosis (Eric)
Registered User

astrognosis is offline
 
Join Date: May 2012
Location: Essex, England
Posts: 9
Celestron Edge F.R. & system's focal length.

Hi all,

I've finally got my paramount ME and C14 edge up and running in the domed observatory.

I am in the process of doing the itial setting up procedeur. I have a question.

I have the celestron C14 Edge x0.7 focal reducer and I'm trying to get the optimal separation of 146mm between F.R. and chip.

The optical trail is C14 Edge + the focal reducer+ moonlite 2.5" CLS focuser + QSI 532 camera.

What I have been attempting is to set the distance between the f.R. and the camera chip at 146mm and then use the 'scope native focusing knob to obtain as best manual focus as I can. Achieving this I assume sets the optimum. Am I correct in this assumptiom?

Assuming the method above is correct I done this and I have plate solved images using, Astrometric, canopus and Pinpoint and find that the actual focal length of the system is 2800mm ( F:7.87) instead of the 2737mm (F:7.7) it should be for the ideal set up.

I find practice increasing the 146mm separation would allow me to reach this ideal situation How much I would need to increase I'm not sure as I have run out of back focus. But I suspect I'm running away from the ideal set up. I think I have used the correct points in the train to measure the 146 mm i.e on the camera side of the F.R the flat flange that the camera or (in my train the focuser) screws down onto.

Ok I know the chip is small and I can depart somewhat from the ideal, but If I later get a larger chip set up it might be an issue. Besides if it was designed to work this way i'd like to get working that way.

Is my method correct? Any advice on this site would be welcome, I have always found it sound and useful.

Thanks, Eric
Reply With Quote
  #2  
Old 01-12-2012, 03:50 PM
frolinmod's Avatar
frolinmod
Registered User

frolinmod is offline
 
Join Date: Dec 2010
Posts: 573
No, not the flat flange. Download an updated manual. The original manual had an error that Celestron have since corrected in the online version. You need to measure from the very back of the reducer (back of the lens housing). The difference is 5/8". See the attachments.

The incorrect reference position is in red, the correct one is black.
Attached Thumbnails
Click for full-size image (Backfocus_with_reducer_drawn_by_FROLINMOD.jpg)
46.5 KB16 views
Click for full-size image (Error_In_Manual_drawn_by_FROLINMOD.jpg)
28.3 KB17 views

Last edited by frolinmod; 02-12-2012 at 04:00 AM. Reason: spelling
Reply With Quote
Reply

Bookmarks

Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +10. The time is now 04:16 PM.

Powered by vBulletin Version 3.8.7 | Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Advertisement
OzScopes Authorised Dealer
Advertisement
Meade Australia
Advertisement
NexDome Observatories
Advertisement
Celestron Australia
Advertisement
SkyWatcher Australia
Advertisement
Lunatico Astronomical
Advertisement
Bintel
Advertisement
Astronomy and Electronics Centre
Advertisement