I always use the hand control port on the base of my Nexstar 11 GPS, and would like to fill the gap on the side arm to prevent dust and dew etc from collecting inside.
Not overly concerned with cosmetics, as long as the rear clip (near the cable) and two bottom retaining holes are intact, and that the unit as a whole is complete and not cracked. Cord not required.
Perhaps I'll also use it as a basis for a future 3D printed cover plate.
Nexstar or Nexstar+
Regards, Dean
Melbourne
Last edited by 38degsouth; 17-11-2018 at 09:38 AM.
Reason: Found, thank you Bryn