Just wondering if anyone has a Takahashi TKA21110 adapter they would be willing to sell. I have one on order from AEC, but can't have too many adapters in a case .
Yep... that is what I am trying to do. From my understanding there are two parts that are similar, TKP35110 (as referenced in the Tak 90 system sheet)… which is 25 mm in length and TKA21110 which was used on the FS78 and is 40mm in length.
I am after the longer one.
Cheers
Daniel
Quote:
Originally Posted by FlashDrive
I take it that your looking for this Adapter.....
It ' screws ' onto the draw tube of a FS78... or ... an FS60CB ....enables a 2" Diagonal to be used.
Did some measuring.... the adapter that I have is 25mm and when screw onto the draw tube allows 18 mm for the diagonal. The nose piece on the diagonal requires 27mm. Therefore I am around 9mm short.
From my understanding, the adapter I am trying to source is 40mm. Claude has quoted me 85 bucks which I think is quite reasonable ( for a Tak product)
Hopefully I will be able to get it in the new year.
Did some measuring.... the adapter that I have is 25mm and when screw onto the draw tube allows 18 mm for the diagonal. The nose piece on the diagonal requires 27mm. Therefore I am around 9mm short.
From my understanding, the adapter I am trying to source is 40mm. Claude has quoted me 85 bucks which I think is quite reasonable ( for a Tak product)
Hopefully I will be able to get it in the new year.
Cheers
Daniel
Sounds about right .... mine is the ' smaller ' one then