You're welcome.
First I'd look at the camera and the syn-scan to see how their network is setup, (I'm assuming the network setting can be seen/adjusted). Set them to DHCP if possible. Same with the laptop.
For the wireless devices, put in the wi-fi password and they should connect to the router and get an IP address. If all goes to plan then check each device to see what its IP address is, and you can use that to connect to the devices from the laptop through their software.
If one or more of the devices cannot be set to DHCP, then you will need to give them IP's. Make them on the same subnet as the routers local IP address. eg: If the Routers local (LAN) IP is = 192.168.1.1 then:
Camera IP = 192.168.1.2
Syn-scan IP = 192.168.1.3
The subnet mask should you need to put that in, would be: 255.255.255.0
You don't need a gateway unless you want internet access on one of the devices. If that's the case, use the local IP address of the router as the gateway address.
Cheers,
Damien.
|