[SOLD] 150750 reflector

[guodong]

[SOLD] Thanks Zane

150750 reflector, Kenko NES mount (144-tooth). In good optical condition. A good choice for beginner. Note there are two broken on plastic parts (cap and a screw), as shown in photo. Bought here more than a year ago, but used only for 4-5 times. Have little chance to use it, so let it go.

No orginal motor drive, I used a EQ3-2 RA drive which is designed for 120-tooth worm wheel. I updated the controller chip for 144-tooth. It worked, but now doesn't, maybe because of the chip. I have another new chip shown in the photo. If someone is interested, I will test it.

Local pick up at Wollongong. Only telescope and mount 150AUD, with drive 200 AUD.

[SOLD] Thanks Mark

And a set of worm wheel for DIY. 144-teeth designed for EQ5 mount, but this one is specially made in copper. 30AUD

Cheers
Gordon

[guodong]

Pics are attached

[Mighty_oz (Marcus)]

pm sent re : set of worm wheel for DIY. 144-teeth designed for EQ5 mount

[telemarker (Keith)]

Gordon,
I'm in need of a helical worm drive for the 144 teeth wheel. Could you let me know if this part is available.

[guodong]

Originally Posted by telemarker

Gordon,
I'm in need of a helical worm drive for the 144 teeth wheel. Could you let me know if this part is available.

Hi, Keith

No proper screw driver in hand at the moment, so can't open the box. I'll try tomorrow. But I bent and cut the supporting shelf to fit this mount and enlarge a little bit the hole connecting to the worm. You may have difficulty to fix it to yours. I'll test the chip tomorrow and then to see whether you can fit your mount or not, OK?

Cheers
Gordon

[telemarker (Keith)]

Hi Gordon,
Sorry, I wasn't clear. I was enquiring after the helical bit of the worm wheel. The part is shown in the attached crop of your photo. If mighty_oz didn't get it, I'll like to get the brass worm wheel as well. Sorry for the confusion.

http://i219.photobucket.com/albums/c...t/ec666ebf.jpg

[astroboy]

PM sent re scope and mount

[guodong]

Sorry, Keith

Misunderstood. I'll let you know if mighty_oz doesn't take it.

To Mighty_oz, your messages box is full, I can't send to you, please clear.

Cheers
Gordon

Originally Posted by telemarker

Hi Gordon,
Sorry, I wasn't clear. I was enquiring after the helical bit of the worm wheel. The part is shown in the attached crop of your photo. If mighty_oz didn't get it, I'll like to get the brass worm wheel as well. Sorry for the confusion.

http://i219.photobucket.com/albums/c...t/ec666ebf.jpg