Losmandy Titan help please

[pmrid (Peter)]

I have titan on order (probably August or a bit later) and am re-emgineering my Obs and the pier it will sit on. I really need some basic measurements though and would be grateful to any Titan owner out there who could run a tape measure across it.
I have a great pier that I will need to lower but the question is "how much" and this will depend on the working height of a Titan in the polar position. So first and foremost, I'd appreciate the height from the mount base (as it would be sitting on a pier adjustment plate) to the middle of the saddle. Second, the distance from the mid-point of the saddle to the RA axis and finally, from the RA axis to the end of the counterweight bar at full extension.
Thanks in anticipation folks.
Peter.

[Lester]

Hi Peter, here are your measurements.

1.= 520mm
2.= 205mm
3.= 550mm

1. is to the bottom of my base plate that the Titan sits in. My base plate is 25mm thick steel, which is held above the pier with 4 x 25mm threaded rods.

All the best.

[pmrid (Peter)]

Originally Posted by Lester

Hi Peter, here are your measurements.

1.= 520mm
2.= 205mm
3.= 550mm

1. is to the bottom of my base plate that the Titan sits in. My base plate is 25mm thick steel, which is held above the pier with 4 x 25mm threaded rods.

All the best.

Thanks Lester. You're a Prince.
Peter