meade dsi + USB extension

[Heian (Mark)]

Has anyone put a USB extension onto the short cable supplied with the dsi? If so, were there any issues with performance? I'm looking at getting a 3m-5m extension

cheers

[elusiver]

even though i haven't used a dsi.. the general rule of thumb with usb is that signal degrades at lengths over 5 metres, how much it degrades is dependant on the device. you can get usb signal boosters though, but they're abit pricey.

el

[acropolite (Phil)]

I read somewhere that the DSI is a fairly hungry beast power wise so you may have problems.

[davidpretorius]

not sure if it helps, but my 5m usb extension is fine for my toucam, no noticeable power differences

[[1ponders] (Paul)]

Check these two sites out Heian. They give the power requirements and recomendations for powering both the ToUcam and the DSI.

http://www.weasner.com/etx/astrophot.../2005/dsi.html
http://www.pc-cameras.philips.com/ma...0_740k/08.html

[mick pinner]

a standard usb cable uses 28 gauge wire, for a DSI you should have a cable with 20 gauge for maximum performance, this is especially true if using usb extensions, the other important factor is computer processor speed.

[westsky]

I use a active usb repeater cable with my DSI, these are 5m in length and you can use up to 5 of these together.
I have only ever used one 5m length
I have heard that the normal usb extension does not work due to the power requirments of the DSI.
Cost was about $20.00 per cable off Ebay
There are USB 1.1 cables and USB 2 cables, get the USB 2

David

[Heian (Mark)]

Thanks David,

it looks like the usb repeater is the way to go....