Arrghh.. I hate myself for this, but here goes:
My chronic back pain is so bad now, that often I have trouble bending over to tie up my own shoe laces.

My 12" scope wasn't the cause, but I really can't justify owning it without having a permanent observatory to leave it set up in. I just can't keep moving it back and forth with my back being the way it is. I love this scope, but the time has come to let someone a bit fitter than me own it. I'm moving to a truss binocular dob that breaks down into lightweight pieces for "easier" transport.....
This scope used to belong to Zane Hammond (owner of Magellan Observatory, NSW) and was well looked after during its couple of years there and has then been under my care since September 2006. The tripod is in pretty good nick, but the paint is getting a little chipped on the legs. The OTA is in excellent condition. There is a little dust on the mirror, as usual - but it presents no optical degradation to speak of. I apologise to Zane for breaking my promise to give it a good home forever.....
Anyhoo - here it is. It's a pretty capable imaging platform - all in one package.
1) 12" Meade LX200GPS with UHTC (Ultra-High Transmission Coating)
2) Autostar II GOTO System incl. 12v power cord
3) Meade Giant Field Tripod - shortened by approx. 8"
4) Meade 7x50 finderscope with dew shield
5) Telrad finderscope with dew shield
6) Meade 26mm Plossl
7) William Optics 2" diagonal with 1.25" adapter
8) Meade Electronic MicroFocusser
9) Peterson Engineering 2" EyeOpener for Meade MicroFocusser
10) Peterson Engineering Bucks Gears enhancement (fitted to Dec only - RA supplied though)
11) Peterson Engineering Dec clutch upgrade
12) corrector plate heater (needs re-connecting)
13) Meade piggyback SLR camera mount for 12" LX200GPS
14) New flexible dew shield w/velcro tabs
15) Bob's Knobs collimation knobs
16) Losmandy machined piggyback mounting blocks x 2 for 12" LX200
17) Serial data cable for scope remote control and software updating
18) Wooden floor-sitting equatorial wedge. Set to 34 deg, but is slightly adjustable. Picture shows Meade 80mm f/11 guide scope attached - which is
not included.
19) Meade carry case for 12" LX200. Zipper is broken, but can be easily replaced. It is slightly water stained (no scope inside at the time!!) but otherwise works well.
20) Meade 12" SuperWedge
Sorry - but will not separate, so
please don't ask
I am asking $5,600.00 for everything, including the wedge. I can deliver to anywhere in the greater Sydney area, or to within a couple of hours drive of Sydney. I will pack the tripod in a separate box along with the accessories and help you arrange transport elsewhere if needed.
Thanks for taking your time to have a look.
Cheers
Chris
(A very sad day for me .......

)