#1  
Old 22-09-2017, 08:19 PM
Granada
The truth is out there

Granada is offline
 
Join Date: Feb 2016
Location: Melbourne
Posts: 150
Question Inserting eyepieces into telescopes

I'm a complete beginner to observational astronomy, so I bought a cheap telescope to try it out. My question is about inserting eyepieces into the holder and fastening them with a screw. Won't the screw damage your eyepieces after a while, no matter how lightly you fasten it? Is there a proper way to fasten eyepieces in the holder that I'm unaware of?


Many thanks
Reply With Quote
  #2  
Old 22-09-2017, 08:36 PM
Wavytone
Registered User

Wavytone is offline
 
Join Date: Jul 2008
Location: Killara, Sydney
Posts: 4,147
This depends on the focusser or star diagonal it fits into, as well as the eyepiece barrel. It also depends on the user - the screw only needs to be tight enough to stop the eyepiece falling out - not moor a cruise liner.

The very cheap ones have a simple retaining screw which as you suggest will lightly scuff the barrel of most eyepieces.

One simple solution is to find a nylon screw that fits instead of the steel one - this won’t mark eyepiece barrels. Nylon screws are often used in electronics and are available in small sizes

The better draw tubes or diagonals have a “compression ring” fitted inside - this is a captive ring that squeezes around the perimeter of the eyepiece to hold it. Slight scruffing might be evident after a lot of use but it’s much better than a simple screw. In this arrangement it’s not uncommon to find as many as 3 screws used to tighten the compression ring on focussers intended to take heavy loads like DSLR bodies, filter wheels or big eyepieces - these loads can be several kilos.

If the eyepiece barrel is stainless steel or steel hard-chrome plated, this will withstand abuse much better than plain anodised aluminium barrels. But that is something you’ll find on premium eyepieces, not budget ones.

Lastly 30 years ago a different solution was quite common which in some respects was better - no screw at all - the eyepiece barrel was a very thin tube with a split cut down the side - and the eyepiece was a firm fit and simply pushed in. This was perfect for small lightweight eyepieces of that era, but inadequate to hold the monster 2” handgrenades from Televue and ES which can weigh a kilogram, nor could you trust it to hold a heavy camera.

Last edited by Wavytone; 22-09-2017 at 09:03 PM.
Reply With Quote
  #3  
Old 05-11-2017, 06:28 AM
AEAJR (Ed)
Registered User

AEAJR is offline
 
Join Date: Mar 2016
Location: Long Island, New York, USA
Posts: 372
If it does mark the eyepiece barrel it is strictly cosmetic and will not impact the performance of the eyepiece or the telescope.
Reply With Quote
Reply

Bookmarks

Tags
eyepiece, eyepiece holder, telescope

Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +10. The time is now 04:40 PM.

Powered by vBulletin Version 3.8.7 | Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Advertisement
Bintel
Advertisement
NexDome Observatories
Advertisement
Limpet Controller
Advertisement
Testar
Advertisement
Astronomy and Electronics Centre
Advertisement