Hi all - was merrily modding my Quickcam 9000, and all was perfect until I accidentally burnt a hole in the USB cable with the soldering iron, leaving a hole, so I set about to repair it... This included trying to repair the first cable... and then from bad to worse, cutting it off and putting a new one on. An idiot, I know... does anyone know of the correct USB cable that I need to buy to replace my botched frankenstein efforts - so that I can get it to work?
I can from time to time with some jiggling get the small light to come on on the PCB, but am not sure what's right / wrong to get a permanent fix.
It's well and truly now out of warranty
but would appreciate any help to get it fixed up - or indeed, can anyone assist for a small fee??
Cheers!