Instructions for Wifi unit assisted By (Rob James)
SYNSCAN Wi-Fi Setup V1
1. Set up the scope
• Do a 2 or 3 star alignment as normal
• leave turned on – but don’t need to select anything special on menu..
2. Connect the Wi-Fi unit
• Ensure batteries are inserted and the unit is turned on
• Then, and only then, connect the cable to the spare port on the bottom of the hand controller. Connecting before turning on can lead to data corruption .
3. Setup iPad
• Go to settings, Wi-Fi
• Connect to the Wi-Fi signal from unit in settings WIFISCOPE4
• Enter the supplied password e.g. telescopeNNNN
4. Initial Setup of Skysafari Pro
• Start Skysafari Pro
• Go to settings, telescope setup
• Choose:
Scope type SYNSCAN
Mount Type (of your mount) Alt-Az or Equatorial German
Click settings to return to previous screen
• Go to settings, communications settings
o Auto-Detect Ski-Fi must be off
o IP address is 1.2.3.4
o Port Address is 2000
o Select “Done”
5. Subsequent Use of Skysafari Pro
• Tap the connect button at bottom of the screen
o Display will show where scope is pointed and sound a ding
o Tapping a target and then selecting “Go-To” will cause the scope to slew to the target
6. Power Down of Scope and Wi-Fi.
• First disconnect the Wi-Fi unit, then turn off
• Then power down the scope as normal – typically park, turn off and disconnect power
Thank you Rob for taking the time to Assist in the correct installation !!