Looking for feedback on auto focusing with a Moonlite Focuser? Is it 100% repeatable? What success rate would you think you have?
The reason I ask is I'm trying to save a few dollars and a Moonlite would be significantly cheaper than the Feather Touch however; Feather Touch use rack and pinion which will always give drive, whereas Moonlite may have slippage due to a Crayford design.
I didn't want to spend half of my money on the full Moonlite setup if it wasn't going to give me the results in auto focusing.
I have just gone down this path myself. I checked with Ron from Moonlite as to load lifts etc. The bottom line is you need to use the correct focuser for the load it will be lifting. I am using a bigger Crayford for a Newtonian (CRL) and tensioned up the lifting capacity to prevent slippage and so far all the V curves and focusing runs have worked well. I am lifting a QSI683 with WSG-8, guide camera and coma corrector. Remember it can sometimes be upside down in various part of the sky. So far nothing has slipped and I am convinced it will be fine. If I were to use a bigger camera and imaging train I would use my Atlas.
Hi Paul, thanks for the feed back. I will be using a QHY9 and 7 position filter wheel, OAG and QHY5 with extension tube and a Tak TOA-35 flattener. Being a refractor it will nearly always be hanging downwards. Not a great load, I guess similar to yours, maybe a bit less. How do you tension it up?
After slightly tightening the two grub screws for extra tension, in over two years of imaging with it, I never noticed any slippage with QSI WSG8, guide camera, and a field corrector on my previous refractor, and the focuser always worked as it should.
However, I do like a greater resolution of motorised FTF and after I learned how to use it, I now prefer my 3.2" FTF over previously owned (and loved) 2.5" motorised Moonlite. FTF really does feel very solid giving an impression as if one could hang a bucket (half) full of bricks off it.
But seriously, I can wholeheartedly recommend a 2.5" Moonlite for your imaging train. You can also get a motorised rotator with it, which I also really liked using with my previous telescope.