I am trying to setup SGPro and I am having some problems with telescope connection.
If I start PHD (or PHD2) and connect to my EQMOD telescope (a HEQ5 via a EQDirect cable), then I am not able to subsequently connect to the telescope with SGPro - i get a connection error message.
If I then disconnect PHD from the telescope, I am then able to connect with SGPro. however if I then subsequently try to reconnect with PHD I get a similar error message from EQMOD saying "connection error - port not available". I am also unable to connect to the mount with StellariumScope after connecting with SGPro.
Any suggestions on how I can connect SGPro, StellariumScope and PHD to my mount (using EQMOD and pulseguiding) at the same time...?
Otherwise I will be back to using PHD and StellariumScope with BYE, which is working just fine.
Thanks