meade rcx400 10" measurements

p1taylor · #1 12-01-2009, 10:55 AM

Hi all
Hope this is right spot for this, I need centers of the 3 base fixing bolts as I hop to mack a wedge as commercial ones are to tall and expensive
peter

AndrewJ · #2 12-01-2009, 06:04 PM

Gday Peter

Have attached a picture of the base dimensions
Try and use the centre hole as well, as it stiffens
the RA axle.

Andrew

(Note: diagram removed as it contained an error - refer to post #6 for correct diagram)

p1taylor · #3 13-01-2009, 01:55 AM

Hi Andrew
Thances for quick reply, I will ues center bolt, had not realised rcx is same as lx200.
peter

AndrewJ · #4 13-01-2009, 07:26 AM

Gday Peter

The RCX base isnt the same "structurally" but the bolt patterns are.
I guess this saved Meade having to make a second type of wedge
just for the RCXs

Andrew

p1taylor · #5 13-01-2009, 08:31 AM

Hi Andrew
Sounds right for today's businesses, use same regardless of weight difference.
peter

AndrewJ · #6 05-01-2014, 02:17 PM

Thread edited to replace incorrect drawing dimensions above with new ones
( as someone found the old one here somehow )

Andrew