Hi
This kit is excess to requirement and consists of:
Robofocus Controller.
Hurst Motor (hardly used) (better resolution and lifting capability than the stock supplied stepper motor).
Power Supply
Cables.
RJ11-Serial Adapter
Cog wheel with a large belt for use with a camera lens.
Coupling - I do not have the original, but I do have a variety of other couplings from a ZWO EFA. Hence it is possible that I would have a coupling to match the shaft of your R&P focuser, especially if its 4.9-5.0mm wide.
I also have a 3D printed bracket for a Takahashi FSQ106.
What I do not have:
The original mounting plates as they were discarded some time ago having been cut and shaped to fit various uses.
$200 posted.
regards
Martin
Last edited by Martin Pugh; 27-12-2021 at 09:10 PM.
Reason: Information added
