DSS issues again

[LewisM]

Been using DSS 3.33 for months now without any problem, with good results.

When I went to stack my latest images, I continually get "Only 1 out of 30 images will be stacked". Now that's odd enough in itself, so I change all settings etc - same deal, no matter WHAT.

So, I load up some data I previously did with it. SAME RESPONSE! And to add to that, when previewing the images, i won't debayer properly any more and just shows horizontal coloured lines.

What the dickens is going on here? I have uninstalled and reinstalled - no difference. Updated graphics drivers (just in case), and all sorts of things, but nope, cannot stack anything!

Any suggestions???

[LewisM]

All sorted - seems the parallel installation of Dss3.32 was messing with 3.33 - not sure why? Removed 3.32, and 3.33 works perfectly as it should.

Odd behaviour.

[bloodhound31]

Originally Posted by LewisM

All sorted - seems the parallel installation of Dss3.32 was messing with 3.33 - not sure why? Removed 3.32, and 3.33 works perfectly as it should.

Odd behaviour.

Interesting. I wonder if that's why my PC with 2GB of RAM used to be able to stack no problems and now is says only one of ---- will be stacked.

I'll look into uninstalling every bit of DSS I can find on my HD then reinstall just one version.

Baz.

[LewisM]

Barry,

After removing 3.32, 3.33 runs a LOT faster, and I get NO out of memory errors (which I shouldn't with 12GB RAM!). So, it seems that having dual installations somehow conflict with each other, maybe a shared dll or something odd.