|
wandererAstro Rotator + plate solving problem (NINA)
Not sure this is specific to the rotator I have - but noticed that when I am using NINA to platesolve, it gets stuck in a loop of rotating from a low angle (say 7deg) to a large one (240+)
I have ended up disabling the rotator because it never finishes. The rotator seems to work, in that it will move to whatever angle I tell it to, so I suspect the issue is with NINA? I only noticed this issue when using my C11 + 0.7 reducer. Dont recall it happening with my refractor.
Any ideas?
|
