Quote:
Originally Posted by sungrazer
Hi
- How do you get the join in the middle to be waterproof?
|
Yes, Just an overlapp of the corrigated Roofing iron, the wheel sets on each half have a small difference in height, only 2-3mm, which allow the weight of one roof half to rest on the other, ie, the lower half goes over the top of the higher half ! odd, but works well since I have also trimmed the lower roof half sheet by 5mm so when they meet, the lower half can climb over the other when closing ! Havent needed to add any rubber seal as they fit very snugg as this type of roofing is also rather springy !
Hope this is understandable ,,
