John K
11-06-2025, 06:45 PM
Hi everyone,
I have just updated to SGP Pro 4 and have run into some issues.
- the ASCOM OMNI simulator activates when I open SGP and then again when I try to open a sequence
- I get an error when I try to create a new equipment profile or a new sequence
- I do not seem to be able to save the settings in any changes to my equipment profiles.
The issues I think started after installing some of the plate solving software.
I am using Windows 11, and SPG Pr 4 version 4.4.1.1411
See the attached errors.
Have also posted on the SGP Forums.
Very frustrating - appreciate your help!
John K.
I have just updated to SGP Pro 4 and have run into some issues.
- the ASCOM OMNI simulator activates when I open SGP and then again when I try to open a sequence
- I get an error when I try to create a new equipment profile or a new sequence
- I do not seem to be able to save the settings in any changes to my equipment profiles.
The issues I think started after installing some of the plate solving software.
I am using Windows 11, and SPG Pr 4 version 4.4.1.1411
See the attached errors.
Have also posted on the SGP Forums.
Very frustrating - appreciate your help!
John K.