nebulosity D810 debayer/demosaic settings

[VS6000]

Hi!
Using nebulosity for the first time and have hit a snag in my processing workflow, I don't know what to enter in the Manual demosaic/debayer settings, like the values for the rgb matrix for my D810 camera?
I've scoured google for the values but no go.
Any help appreciated!
Cheers, Tim

[vlazg]

Hi Tim, there only 4 choices, 00,01,10,11. Trial and error until it looks right, only one will.

[VS6000]

Thanks heaps george!!

[VS6000]

So, one of those values at a time with the other 3 at 0 or? Sorry im very green with processing atm!

[Atmos]

It'll possibly be down as RGGB or RGBG or GRBG or GRGB :)

[VS6000]

Aha! Thanks!

[VS6000]

Actually, still stuck...
So which fields do i stick those numbers into and in which possible combinations? And when it's done right, the colours should be reasonably accurate as to what was shown on the camera at the time?

[vlazg]

The pixel size may need adjusting if they are not square, if they are you can leave this alone ( 4.88 )
the colour control you can leave alone
The matrix offset will need adjusting to any of the settings as stated in my previous post, just use one sub to try each until you get the correct setting , one will look right, the others will obviously be wrong

[VS6000]

So im only changing the values that are currently 1? And change one at a time? That will be a lot of possible combinations!

[vlazg]

I think you are looking at the colour control, leave this alone.
The matrix offset , lower left, is the one to adjust, there is only four combinations

[VS6000]

Im an idiot, thankyou very much!

[vlazg]

No problem, i only know this because i went through the same learning curve,