3.35 NEQ6pro

[jenchris]

When did that software come out?
I just installed it and it is much more compreshensive than the 3.28 I was using.
I was able to do a non polar scope SCP align and turn down the LED on the polar scope as well -
Are there any other updates that are worth inserting?:question:

[coldknights]

Have you done the motor controller firmware update ?

http://www.skywatcher.com/downloads.php?cat=3

It helped with our eq8:thumbsup:

[jenchris]

No not yet - what does it do?

[coldknights]

Have a look at the link it helps with auto-guiding it disables power saving when auto guiding is detected.

[jenchris]

says it is for the EQ8 - no mention of the 6

[coldknights]

It is there look harder !

[jenchris]

Got it ta

[acropolite]

Re the motor firmware, there were some problems with spikes in autoguiding, the motor firmware is supposed to overcome that.

[Marios]

I had all sorts of problems with various Synscan firmware 3.35 being the worst. Get off the hand controller and onto ASCOM it will be worth it long run.

[jenchris]

I daresay you are right, but I will learn the handset first and then ascom - because I don't have a direct link cable....