DIY dew controller?

[garymck (Gary)]

Hi looking for a DIY dew controller...the project kit on IIS seems not to be available. Are there any other kits around that would be suitable? eg
Jaycar CAT. NO. KC5225 10A 12VDC Motor Speed Controller Kit ?

I'm not electronically literate, but did complete a Cookbook 245 successfully, so I can follow instructions!

Is there any chance that a PWM controller will generate noise that would affect a CCD camera? I seem to recall that old Kendrick controllers had this propblem?

cheers
Gary

[Astroman (Andrew Wall)]

Thats the exact kit I used for my Dew controller, With the exception I also added a 10K potentiometer soldered to the existing on board pot so I could adjust the heat to maximum of only 500mA which is more than enough for my Strap that I used for my camera. The strap I made up of a couple of lengths of coaxial cable which I flattened with a hammer and lightly rubbed it with sandpaper to expose the copper... I soldered 16 390 ohm 0.5w resistors to this 18mm apart for my strap. this varies and I used a spreadsheet to work all this out, I think it's available via the DIY controller described on IIS.

I also have two other sockets ready for another two straps but haven't done these yet. The circuit is more than enough for all of this... You could almost say it's a little overboard, but works well...

As for interference I am not sure...

[GTB_an_Owl (Geoff)]

gary

don't bother with the kit

buy ready made

i chose the 3 amp model but there is a larger one

http://cgi.ebay.com.au/ws/eBayISAPI....=STRK:MEWNX:IT

12 volt input is the red led end - motor output the other (just check with meter which output terminal is positive)

geoff

[garymck (Gary)]

good idea...

cheers
Gary

Originally Posted by GTB_an_Owl

gary

don't bother with the kit

buy ready made

i chose the 3 amp model but there is a larger one

http://cgi.ebay.com.au/ws/eBayISAPI....=STRK:MEWNX:IT

12 volt input is the red led end - motor output the other (just check with meter which output terminal is positive)

geoff

[erick (Eric)]

And here is a local one:-

See http://www.kitstop.com.au/page10.htm

I've just bought two of the pre-built FA804-M $36.14+$8.45 postage - as spares. They both checked out well, under load, on an oscilloscope.


FK804-M 40 Watt 12V PWM Controller Kit This is MOSFET version of our standard FK408 PWM. Use it to control DC motors up to 3.2Amps and 12V lights to 42 Watts. Experiment with LED dimming. Yours Now!! at $AU11.73 including GST plus $4.60 P and P
Now also available Pre Assembled as FA804-M for $18.07 inc GST plus $6.45 P and P)

[GTB_an_Owl (Geoff)]

think my two came to $26-80 and took about 8 days

geoff