still testing my qhy10 but tonight i tried to set the temperature to -15 below ambient but on the bottom left it was saying that it was not going below 24.8!
am i missing something? also i know it was not cooling because the blue temp line was going along the top of the graph, i have seen it travelling along the the -15 line the last time out
any ideas?
pat
HI Pat could you here the cooler actually running?
Sometimes it would come loose and the temp wouldn't shift.
Also I had better response setting the temps in MAxim than in Nebulosity to be honest.
Sometimes I had to unplug everything then replug it all in in sequence to get the cooler going again if it came loose
MaxIM controls cooling VERY well for all cameras I have used. It managed the recalcitrant ATIKs I had much better than ATIKs own software. Same for Starlight Xpress (I sometimes wonder if the same person who wrote ATIK's stuff wrote SX's too)
thanks lewis and graz
i am using their ezcap, and the last time i went out it was cooling fine, according to the graph anyhow, and yes graham the fan was working so i gather the cooling was on?
pat
HI Pat, sometimes the settings on the DC box need a look see. There is a blog on the QHY website about setting the numbers for max cooling -I just left it alone but it is possible to press on them accidentally and change the cooling settings manually.
I will try and find it for you. All three numbers I think should be on with connection plus the fan on,
ah that possibly could have happened graham........ i think i will set it up again tonight and see what happens after a another good read of the manual again!
pat
Its a shame you don't get an error of some sort if the cooling circuit isn't active. Can't count the number of times I've started imaging to realise I hadn't powered the DC-201 for my QHY9. Software sending cooling messages, but they don't do much good
