Hey Martin,
Yes I printed them out and was following it.
This bit here:
Quote:
Do the same for Dec , similar procedure but using the level on dovetail plate until it is horizontal
facing east west. Once level rotate the Dec 90 degrees so it ends up on “0” at the Dec arrow pointer.
Again you have move the Dec axis 90 deg
|
It is at 0 without rotating it? In the home position (counterweight down)..... So in the home position, when i click telescope in, its facing East/West before i go any further.... Hence the picture.
If i move that section 90 degrees so it faced north south, the pointer is to the side and pointing to 90