Quote:
Originally Posted by strongmanmike
Looks professional in that close up, nice
Mike
|
Thanks Mike .Professional
. I wont show a pic of the outside yet, its too embarrising, much adjusting was done, so many extra holes
.
Quote:
Originally Posted by sheeny
Well done Fred.
As an engineer I appreciate the challenges of your design, and I'm following with interest. Nice job on the bending.
Al.
|
Thanks Al. As an engineer, you must groan at what hackers like me do
. Everything is from bunnings and hand tools, its sooo time-consuming. I bet theres a 1000 better ways to do this but I DONT CARE. Im dodgy and proud
Today, guide rollers.