Sounds like it works. I am still using the squirt bottle but swirling around seems work to spread the grit.
I also went back to 14000 pre polish to fix my turned down edge using the circular edge technique and that was working all be it slowly. So I built the rotating part of a mirror o matic 14/ 20 and back to 800 grit, fixed problem in an hour. Then went slightly too deep then back to slightly to shallow in 20 min. Very effective short circular motion on the rotating platter at 35rpm for getting TDE down and the polish is still good enough to test.
Next , install the mirror o matic arms and on to the 12 inch once I can work out how to figure the 4 inch F4.
|