|
Hi Bert, Alex
I am converting Nexstar 11 to OnStep for a friend (Ritchie-I) because the electronics is fried (previous owner reversed the power, then someone was swapping cables on motor board and managed to force 12V onto 5V VCC rail.. so the whole thing is damaged beyond easy/low cost repair).
Could you please share some more mechanical details of your conversion/implementation?
I can see to some extent what you did about arm motor, but it would be nice to see how you did the Az axle as well.
I am thinking about using 16/80, GT2 belt transmission, I think it will fit (with short shaft extension).
Thank you in advance!
Bojan
Last edited by bojan; 14-11-2021 at 11:32 AM.
|