|
I have noticed that your schematic (hand-written one) uses CTS (pin 8) as an output, while other use RTS (pin 7, PC users).
Better check which one is activated by your application (you can do it with voltmeter... If not active the voltage will be -5V ... -10V, if active it will be +5 ... +10V)
BTW, I added toggle switch in parallel to a transistor, so I can use the same cable in manual mode... no need to touch the camera and provoke the vibrations :-)
Last edited by bojan; 10-10-2007 at 04:58 PM.
|