Hi Luka. If it helps. The back of the 450D sensor (1000D and 550D) is not conductive. The camera chassis is ground and the cold finger is bonded to the chassis - and, it follows, to supply ground.
The apparent emphasis on bonding the copper finger to the camera chassis, was a matter of ensuring that the cold finger (antenna) and camera shared a common analog ground - when running the camera with batteries - separate from the cooling system supply, which is likely affected by PWM switching.
Irrespective of camera design, it should be cold finger to supply ground. On a single analog / digital board, I connected AGND and DGND with a 1uH inductor.
|