If only they were on round boards..
I had that camera earmarked for an attempt at debayering, but I might mill an enclosure for it once lockdown is over and I can go back to capral and get some off cut stock for it. I never added temperature regulation, it was just a simple LM317 current limiter but for something USB powered it was surprisingly effective at 400ma (with a powered USB3 hub though). It would get down to between 0c and a few degrees above sitting on my desk after some time.
I have a set of thread mills now too that I'm looking for something to make with to get some practice, so I should be able cut the threads for a 1.25 filter into the nose of it.
|