Quote:
Originally Posted by AdrianF
I have just received one of these 6amp switching reguators from Texas Instruments and I am in the board design stage, using pencil, paper and a sharp knife so it going to be an "ugly board" construction. Hopefully will have it finished by tonight for my session with the scope. What software do you use to design the boards? Usually I would use Protel but my licence as run out and cannot justify the cost to reregister the software.
Adrian
|
Adrian, why do you even bother with an circuit board?
I have mine in a small box with the components straight on the converter.
For only 4 components you don't need a board.