Hello,
Thanks for the extra suggestions, the only reason I am picking 1" at .001 is a suggestion from one of the ATM website, Mel Bartel or similar.
I did noticing that some of the tolerances were greater than the increments on some of the dial indictors. Also an issue with going more than X amount of turns from zero prior to tolerance shifts when measuring.
Its for a Foucault/Ronchi tester I want to build, hence the 1" travel, I assume to make setting up easier.
Thanks
Steve
Ps. The Mitutoyo products have a nice table for all the dial indicators, size, travel, tolerances etc, all on one table which makes looking up the model specs very easy.
|