View Single Post
  #15  
Old 09-08-2021, 02:15 PM
bojan's Avatar
bojan
amateur

bojan is offline
 
Join Date: Jul 2006
Location: Mt Waverley, VIC
Posts: 6,932
Gears fit, but a bit too tight.. perhaps I will print them again, slightly smaller.
On the other hand, the red flange is not flash with scope back end, so the bracket is slanted and motor shaft is moved towards big focuser gear...perhaps 2x 0.5 mm spacers and longer screws will help here.
Anyway, not bad at all for first iteration


EDIT:

With washers under the bracket, gears fit perfectly (as much as plastic can...).
Attached Thumbnails
Click for full-size image (DSC_0911.jpg)
199.4 KB144 views
Click for full-size image (DSC_0913.jpg)
200.2 KB134 views

Last edited by bojan; 09-08-2021 at 02:44 PM.
Reply With Quote