|
Thanks for the replies,
Yes 100% sure all flats and Bias were taken right after the Lights were done.
So that part is done correct then, just Flats and bias.
I wanted to make all setting weren't changed at all.
I have had this light glow issue now on a few attempts, i thought i was a flats issue, so lowered the ADU from 30000 to 22000 for this run to see if it helped, afraid it didn't though.
I uploaded the files on here to jpeg and reduced them by 25% as they were a tad large.
Tried uploading the same version but at 100% but it won't allow it here.
I am not sure where else to upload the full version to yet, will have to look into that one.
Will look at replacing that flat cable, If they make a shielded USB A to B cable, that would be best, If so i would also look at replacing the cable inside the mount to a shielded version also.
I am now thinking if it could possibly be a smoke haze for a neighbors fire,
Was sitting at about 1 degrees outside when these were taken.
Next thought was to do a back to back comparison with my DSLR, run an image session with the DSLR then swap it straight over to the asi2600mc and run that , but the specs say that the asi2600mc should be far superior in all areas.
|