Quote:
Originally Posted by Startrek
Hi Peter,
9/Stacking Parameters, Calibration Frames use Median
Martin
|
I am going to go back over and re do the stacking program again as there are a few things on there that i do need to change.
In regards to this one:
9/Stacking Parameters, Calibration Frames use Median
I can't see that option anywhere in DeepSky Stacker.
I even downloaded the latest version just to make sure.
Under the Stacking Parameters tab i re set the Lights, Flats, Bias to the suggested settings.
But i can't see the Calibration Frames tab,
The only thing that i found remotely close was in the Cosmetic tab.
If i click:
Detect and Clean remaining Hot Pixels,
Detect and Clean remaining Cold Pixels,
Then you get the option:
Replace pixel value with the median Test on first Frame
I selected this option and and let it do its Test on first image
It take a little while, but came back with:
Detected Hit Pixels 832023 (3.19%)
Detected Cold Pixels 1494800 (5.73%)
Also left the Alignment method as Automatic.
Sorry for dragging this out, but definitely learning some very valuable information here.