|
Update:
BPO since you have been using yours for a while I have a few questions.
The unit works fine, but I am not sure about an error I think is going on and I think I may have caused it.
In the Network Tab I set the folder for User data file destination into a folder in my documents. Likewise I set up the CCDA4 file into my documents too.
I also changed the names of each of the file names.
What I noted yesterday when I started up the system is that the file names had changed again and the AAG software was back at the default destination again.
The "instructions" don't seem to have a save as function and I am wondering if I have done something wrong? Where did you put your files and folders and did you change the names?
Similarly the destination also is being watched by my dome software and this did not seem to update as before, so obviously something is wrong.
I will look at the K values too as you suggested earlier
|