Quote:
Originally Posted by Satchmo
Mike
I am doing a course on 2D CAD on Turbocad so this interests me .
I can understand that your cutting window is 1000 X 700 , so can you hold larger pieces of wood on the table than 1000 X 700 ? Would some kind of ancillary support table assist there ?
Mark
|
Hi Mark,
The actual bed size is 1300x900mm and there are no pass doors like on some lasers(my other less powerfull laser comes with it). However if your piece is no wider than 1300mm we can try to do longer than 900mm piece with the front cover open and supporting the hanging part of it outside of the laser machine. The only problem if your design is going through the whole length of material with no gaps. It may be very hard to align lines if it needs to be cut in two steps with material rotated 180 degrees after the first step.