Quote:
Originally Posted by Lester
The power supply was putting out 12.8 volts so I changed it for a new 13.8 volt 10 amp supply I had for a spare and still get the same RA motor lag/not tracking message. This is with both motors disconnected from their gear boxes, so no binding of gears etc.
Is there anything else I can try? Thanks.
|
Hello Lester, My Titan does that occasionally - and the culprit has always been my worm setting. Although I tend to "set and forget" the worms, they do occasionally get a bit clagged up - changes of season (heating/cooling metal parts changing the gaps a bit is a possible culprit. Also, not using the mount for a while may have seen the grease get a bit clagged up - perhaps a bit of sea air would aid that process.
Anyway, I have generally found that a worm rest did the trick. If you're doing that, you could take the opportunity to judge the state of the grease as well.
Peter