|
Hi Simon,
I knew sometime ago that you finished, not sure why but have an idea based on other staff mumblings.
The pipes are 170mm outside diameter and the tube is 6mm thick. The centre shaft is 36mm diameter but has a small amount of rust on them so I expect they need turning down to remove rust.
I have some smaller rollers but believe the shafts are super thick. I can lift the long roller on my own but the smaller roller I cannot lift well at all.
Thanks for the question as I needed to get that information. The next step is a 6 to 10mm plate for the base. I will get that at the same time I get other metal including a welding bench-top.
|