Quote:
Originally Posted by richardda1st
Hi Allan
Check out this pdf file, let me know if you would like to change anything.
Cheers
Richard
|
Thanks Richard,
It worked a treat.
Printed on A1 ($5 at the Copy Shop)
Laminated ($15 same place)
Very Happy Thanks again
One possible improvement, for future users, would be to try to make the scale a little narrower, so that the notch to be cut in the top board of the base does not interfere with the azimuth friction pads.
Maybe limit it to 2cm rather than just over 3cm.
Mine actually runs on the Bunnings lazy suzanne modification (from IIS projects) so it was not a big issue for me.
