|
Its just trail an error...if the backlash is not that bad just go into setup and go to set backlash for the correct axis....it will have a default setting but try incresing the value...for eg...it may be set to 2500...increase it to 5000 on the correct axis.....remember you have both RA and DEC axis.....the up and down arrows are DEC axis and left and right arrows are RA axis...so try adjusting the correct axis and test....if all fails just put it back to the default backlash setting as first seen.
Let us know how you go.
it's all trail an erroe...and unless your imaging and guiding as long as it's fairly close it wont make much a difference....it does not have to be perfect....it really only needs to be spot on if your guiding for imaging.
|