View Single Post
  #8  
Old 28-12-2012, 02:31 PM
LAW (Murphy)
Registered User

LAW is offline
 
Join Date: May 2012
Location: Brisbane
Posts: 204
I'll be fabricating a tube. Basically the rough plan is to make a 50" tube of four layers of 4x4 in alternate directions, the primary cell will be a sandwich construction of carbon and balsa wood with threaded inserts for the collimation screws. As carbon fibre has a tendency of corroding any metal it touches it will all be installed 'wet' with sealant, which should also help prevent vibration.

I don't know what I'm looking at with Newt Online, the parts I do understand are very informative however. Would someone who knows what they're looking at care to give me some feedback on this setup please?


I don't really understand the vignetting of the 75% ray? The 100% area is almost the same size as the sensor in my 450D so does it matter that the 75% ray is cut off a little?
Attached Thumbnails
Click for full-size image (newtdimensions.png)
45.5 KB23 views
Click for full-size image (newtperformance.png)
61.1 KB17 views
Click for full-size image (newtraytrace.png)
90.0 KB30 views

Last edited by LAW; 28-12-2012 at 02:54 PM. Reason: updated newtonline data
Reply With Quote