Bringing up an oldish thread. I would like to give Ken Crawford's "Digging out the Details" process ago
http://www.imagingdeepsky.com/Presentations.html. One of the steps is to Deconvolve using CCDStack. Firstly, data has been collected from a modded Canon 30D. The picture I have loaded into CCDStack is one in which I used DSS for stacking/calibration --> loaded into CS3 --> curves/grey point/black point --> converted to greyscale (pseudo luminance) --> load into CCDStack.
The first step after clicking deconvolve (process tab) is to then click auto-select stars. This is where the problems begin. It doesn't select stars. You can manually (double-click) stars which I do and then it should bring up star details including FWHM but it doesn't. It just brings up general info about the area clicked e.g.
rectangle {X=2107,Y=522,Width=3,Height=3}
diagonal 4.24
# pixels 9
# rejected 0 (0.00%)
mean 22,041.78
STD 1,854.25
S/N 11.89
median 22,018.00
int mode 19,568
min 19,568.00
max 25,194.00
R:G:B ratio 1.00 : 1.00 : 1.00
Any ideas?