Quote:
Originally Posted by gregbradley
Do you think I may not have gotten the correct tension on the belt that drives the worm?
|
It is possible that your belt is not tight enough. I read on the SB forum that you could not over tighten the belt. It was Steve or Daniel Bisque that said this.
I would be reluctant to put a lot of pressure on the belt, but when you push in on one side the other side should not move.
I don't know if this would cause the oscillation but it would be worth trying.
Keep in mind this may alter your PEC and TPoint Model.
I have only done some quick tests with the guide function on Sky X, but I have found at my image scale, I had better results unguided.
I did a log and found there was an oscillation also, +- 2 arc seconds. I put this down to the settings. I haven't had a chance to explore this further.
Cheers.