|
Cooler Box
Hi Chris.
What I did with my the past setup was that I drilled a small hole through the t-piece into the nose piece and inserted a pin, that prevented any slip because of the weight of the ?
(you know what). Another solution is to use super glue on the thread.
I have slots in my plywood tube enabling me to move the mirror up or down to suit the position of the focus in the focuser. For example, the focus of the camera in the cooler box is about half way up from the wall of the tube leaving me plenty of room at the back of the cooler box, clear of the finder scope. I have 2 screws I use to tighten the cooler box in the focuser, tight up against the insulation, but it is ok.
Where is the ac adopter located? not inside the cooler box?
You might consider calling in any Friday night at the pony club site in Bannerman Rd
Kenthurst, to look at my setup. Or for that matter, any night, just let me know.
|