Has any one else tried putting unmounted filters in a qhy wheel? I have the bag of nylon screws/washers explicitly for the job but they seem to have 3 screw holes for these instead of the usual two. One is on the far inside edge of the filter hole. This obstucts the carousel from seating on the central drive wheel,the washers get in the way.
Do these guys even test the stuff they make or look at how others do it? Sure, I can get a pair of cutters and snip a bit off the washer to make it fit but that is not the point. Obviously they didn't even test it or they would have fixed it. I wanna see one screw/washer holding down 2 filters, isn't that the way it's normally done?
Grrrrrr ... Both Paul Keating and Forest Gump's mum were right .....
