|
Thanks guys for the comments.
Mark, I have not regreased the mount since shortly after purchase. I did use a liberal amount but not excessive. Well at least I thought so. I did try to follow the tutorial on regreasing on you tube, but being my first time I might have put just a bit too much. The grease I am using is the one recommended by SB that being lubriplate 105 grease. I have seen this before up at Moorook where there was grease dripping out on a warm day of at least 10 mounts.
Your mount is relatively new and you most likely have not regreased yet from factory setup, so you should not have too many dramas yet.
Each time I cleaned the sensor there was oil from the grease. It must roll down the inside face of the wheel and onto parts of the wheel that are read by the sensor, an easy enough task with these mounts I think.
Limits are not an issue, non set, only hard stop. Each time this has happened it is in a different position. However I am not discounting the fact that the homing sensor migh be at fault, that does happen and I don't really know how old this mount is. Perhaps Ken could shed some light on this?
If it happens again I will need to think about other options to solve the problem. Until then let's hope nothing else can go wrong.
|