[gregbradley]

I got an SBIG STi to replace my Lodestar.

I installed the software as per the manual. I noticed my version of CCDSoft did not have STi in the drop down menu on the setup tab.

I installed the later version of CCDsoft from the supplied CCD.

It now showed STi as a selection.

I ran SBIG drive checker 32 bit (that computer runs XP).

Now it doesn't connect to my FLI Proline and filter wheel. I checked
if they were connected in Control Panel, device manager and they are there and look OK.

I turned off the camera and restarted it and restarted CCDsoft.

Same, no connection to the FLI camera.

I did this several times, same result.

I then ran system restore to get rid of the changes and it seems to be bogging the computer down to a blank red screen with only the mouse pointer on the screen.

Any suggestions?

Greg.