G'day Peter
Thank you for your input.
Quote:
Originally Posted by Peter.M
I think you will run into the same problem with this, I am no expert but I suspect the downfallings in your eq6 weight capacity wise are not due to the weight capacity of the actual structure.
The torque needed to move heavyer objects is what gives a mount its capacity. This comes from the motors so obviously you will need strong motors to run this mount when you put a large load on it. Im not sure the cost of the motors will be economical (I have not looked into this) but I dont imagine that they will be cheap.
|
I agree with your comments, however the difference I feel between this project and my EQ6 mount is that I can more readily adpat and change the older mount (i.e. adding motors and gears). Where as the EQ6 is limited by its design and structure.
I am looking at larger (higher ratio, maybe 240 to 360 teeth) worm drives/gears for this mount, with better motors.
Thanks again and if you have any further advice in relation to gears, best placement location or any other considerations. I would be happy to receive them.
Clear Skies
Gav